fill my day Coming to BristolComing soon

COSTS

What it costs to fit an outside tap

What a plumber charges to add a garden tap, why the position matters more than the tap, and the check valve the regulations ask for.

IN SHORT

An outside tap on the wall behind your kitchen sink typically costs £80 to £150 fitted, usually including the tap, according to MyJobQuote. A wall with no pipes nearby is more like £180 to £250, and a tap at the bottom of the garden can run to hundreds. New outside taps need a check valve to stop garden water flowing back into the mains.

This page is part of our guide to plumbing costs in the UK. Every figure below has its source named and dated at the bottom of the page.

Cost to fit an outside tap

An outside tap typically costs £80 to £150 to fit, with an average of about £120, according to MyJobQuote. That's for the simplest position, the outside wall behind the kitchen sink, and it usually includes the tap and materials. The job takes up to half a day.

SOURCEPRICEWHAT IT COVERS
MyJobQuote, September 2026£80 to £150, average about £120Kitchen-sink wall, usually including the tap and materials
Which?, May 2026£80 to £400, about 2 hoursWall behind the kitchen sink; labour and materials, VAT extra
MyBuilder, undated£50 to £200Depending on the tap and the work; £100 to £150 for a frost-free tap

Where the tap goes decides the price

The tap is cheap. MyJobQuote puts a standard garden tap at £6 to £10. What costs money is getting water to it. MyJobQuote prices it by position:

POSITIONPRICETIME
Wall behind the kitchen sink£80 to £150Half a day
A wall with no pipes behind it£180 to £2501 day
Bottom of the garden, pipe run along the surface£300 to £4001 day
By the back door, with a new gulley to the drain£800 to £9502 days
Bottom of the garden, pipe buried against frost£1,000 to £1,2003 to 4 days

The jump at the end is digging. A buried pipe has to go deep enough not to freeze, and the ground has to be put back afterwards. MyJobQuote says a hot and cold outside tap adds about £150 to £300 more.

The check valve, and other rules

A new outside tap needs a double check valve, a small fitting that stops water in a hose flowing back into the drinking water supply. MyJobQuote explains that this comes from the Water Supply (Water Fittings) Regulations 1999 in England and Wales. It says the valve is best fitted inside the house, where it won't freeze.

  • Older outside taps sometimes have the valve built into the tap itself. MyJobQuote says that's no longer allowed for new installs.
  • An isolation valve inside, so you can turn the outside tap off for winter, isn't required but MyJobQuote recommends one.
  • Buried pipes need to sit roughly 750mm to 1,350mm deep, says MyJobQuote. Outside that range, the work has to be notified to the water supplier.

A plumber should handle all of this as part of the job. It's worth asking where they plan to fit the check valve.

Replacing or removing an outside tap

If you already have an outside tap that leaks or has frozen, replacing it is simpler. MyJobQuote gives £80 to £150 for a like-for-like replacement, including the call-out, rising to £200 to £400 if the pipework is corroded. MyBuilder puts a replacement at £60 to £120. Removing a tap and capping the pipe is £60 to £120, says MyJobQuote.

What else changes the price

  • Frost-free taps. These cost more to buy but are less likely to burst in winter. MyBuilder puts fitting one at £100 to £150.
  • Access. Lifting floorboards, tight cupboards and long pipe runs all add time, says MyJobQuote.
  • Where you live. MyJobQuote says plumbers in London charge about £20 to £60 more per day than in the north.
  • The minimum charge. MyJobQuote puts a typical minimum call-out at £60 to £80.

Need a plumber in Bristol?

An outside tap on the kitchen wall is a tidy half-day job, the kind that fits a plumber's free afternoon. Fill My Day is coming soon to Bristol, free to use at launch, and isn't taking bookings yet. See what's launching in Bristol.

Where these figures come from

GOOD TO KNOW

Questions,
answered straight.

How much does it cost to have an outside tap fitted?

MyJobQuote puts it at £80 to £150, averaging about £120, when the tap goes on the wall behind the kitchen sink. That usually includes the tap and materials. Which?'s Trusted Traders quoted £80 to £400 for the same position, VAT extra.

How long does it take to fit an outside tap?

About two hours on the wall behind the kitchen sink, according to Which?. MyJobQuote allows up to half a day, and a day or more where pipe has to run further.

Does an outside tap need a check valve?

Yes. MyJobQuote explains that the water fittings regulations require a double check valve on a new outside tap to stop water flowing back into the mains, ideally fitted indoors so it doesn't freeze.

How much is it to replace an outside tap?

MyJobQuote gives £80 to £150 for a like-for-like replacement, including the call-out, or £200 to £400 if the pipework is corroded. MyBuilder gives £60 to £120.

FIRST STOP / BRISTOL

Bristol.
You’re up first.

The app is in development and isn't taking bookings yet. Plumbers first, other trades to follow.